Due to the use of the Windows operating system, the Demina tool grinding machine can configure the independent research and development of the tool grinder monitoring cutting system. This system has the following advantages over the traditional retiring board.
1. The screen only displays two rings, one is the reference grinding radius ring, the other is the allowance adjustment ring. You can customize the radius size for both circles. Ensure grinding of all visible dimensions. with two circles of color can be customized.
2. The Angle of the blade can be drawn on the basis of the ring, which can quickly realize the determination based on the blade matrix position.
3. The center position of the reticle can be adjusted arbitrarily to ensure the grinding of large R-size cutting tools. Cross the line can be rotated around the center point of the crosshead, and the display position of the grinding surface of the wheel can be adjusted the whole. All other shapes are rotated at the same Angle.
4. Can load DXF two-dimensional graphics file, grinding tool can be compared with standard graphics grinding.
5. The thickness of each wire is a one-pixel unit to ensure the accuracy of the circle size as far as possible.
6. The image can be magnified up to four times as many pixels at various optical magnification rates in the times. After the rate amplification, no adjustment to the tool center is required. Save time for knife alignment.
7. When grinding the belt rake blade, it is necessary to leave some allowance for the first back Angle to the final ruler inches. The software provides the measurement Angle according to the front Angle of the blade, the tip of the tool, the first rear Angle, the second rear angle, the width of the rear Angle, and the final radius of the blade. Automatic calculation of the second grinding Angle when R-Size, as well as the primary, secondary back Angle grinding Angle, users can quickly achieve tool grinding cut shape!
8. Support users to configure third-party secondary detection software!
