APE 60 universal drill tool grinder is widely used in industrial production. Before using the equipment, we generally debug it. It will be put into use after normal debugging. Today, Demina will introduce the debugging operation process of the universal drill tool grinder.
Commissioning operation process of APE 60 - Sharpening Machine
1. During operation, the grinding wheel and the slide table are adjusted to a certain small angle so that the front edge of the grinding wheel contacts the blade to ensure the quality of the blade.
2. The amount of knife can be adjusted by shaking the handwheel to move the slide base back and forth.
3. The angle of the sharpening knife can be adjusted by turning the adjusting wire and adjusting the sliding table.
4. The amount of extension of the knife can be adjusted with a top wire top knife.
After using the sharpener to adjust the above several parameters, use a compression wire to fix the blade to be sharpened on the blade holder through the pressure plate. And then push the blade holder to the left and right to carry out the grinding operation.
Reasons affecting the sharpness of the sharpening machine
The sharpness of the is very important. It can effectively improve the efficiency of sharpening.
The installation and adjustment of the sharpener will affect the sharpness of the sharpener. When installing, pay special attention to the stability of the device. A stable device can ensure that the firmware is firmly connected to prevent device vibration.
Secondly, the composition of the equipment abrasive will also affect the sharpness of the precision APE 60 – sharpening machine. If the abrasive contains too much corundum, it will easily wear the blade. If the amount of diamond is too small, the blade is not easy to sharpen, it needs to ground for a long time, and it is easy to deform. In addition, the operation method of the sharpener has a great influence on the sharpness of the sharpener, so it is necessary to master the correct operation method.
